8. After editing the mask, press SAVE USER MSK to save the mask data.
Copying a Mask
Use the following procedure to copy a mask. The procedure first activates a mask and then brings the mask into the editor. If you are copying data from a user mask, you can skip activating the mask in steps 1 and 2 and directly enter the mask number in step 3. (Skipping steps 1 and 2 eliminates the need to recall a mask along with its attempt to locate a signal. However, you cannot copy from an agency mask if these steps are skipped.)
Note
Entering the number of a mask that has not been created displays the message Valid mask mustbe loadedor youmust start a new mask. 1. Activate the mask to be copied using one of the following methods:
n n
Press RECALL USER MSK and select a user mask. Press AGENCY MASKS and select an agency mask.
2. Press MORE 2 of 2 . 3. Press MASK UTILITY and then EDIT MASK to display the first edit prompt: ENTER # OF MASK <= 11. 4. Press NEXT ENTRY or, if step 1 was skipped, enter the number of the mask to copy data from and press [ENTER). (Agency mask numbers cannot be entered.) 5. The indicator EDITING MASK appears on screen. 6. Press PREVIOUS ENTRY if displayed. 7. Enter the number of the new mask, and press (ENTER). 8. Press the SAVE USER MSK to save the mask dataunder the new mask number.
